![]() ![]() Setup the IP address of ETH2/2 with the command "set ip". IOFPGA 0xd0000000 version=0x30020700, datecode=0xc080d17 CPLD version 0x14įilesystem type is ext2fs, partition type 0x83ĥ. This is the only interface that works at the time of the recovery process.ģ. Connect the CAT5 cable from the local pc NIC to the CGR ETH 2/2. If your network is live, make sure that you understand the potential impact of any command. All of the devices used in this document started with a cleared (default) configuration. The information in this document was created from the devices in a specific lab environment. This document is restricted to only CGOS version running on CGR 1120 and CGR1240. The kickstart image and the system images Components Used Setup the TFTP server to have the kickstart image and the system image RequirementsĬisco recommends that you have knowledge of these topics:ģ. Trivial File Transfer Protocol (TFTP) server installed on the local PCĢ. The procedure outline in this article is to restore the CGR from a corrupted SD card memory state.ġ. The sequence for the bootup is outlined in the given figure. ![]() As a result, the kickstart image and/or the system image gets corrupted. In rare occassions, the SD card gets corrupted. Background InformationĬGR1000 use Cisco Secure Digital (SD) Card memory to stored kickstart images, system images, configurations, etc. This document describes troublshoot steps to recover bootflash and system image on CGR 1000. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |